Response keywords

The keyword in a response line specifies what to do with the responses you receive from the remote computer, as follows:

```
OK=remote computer response<macro>
```
The script continues to the next line if the response or macro is encountered.
```
LOOP=remote computer response<macro>
```
The script returns to the previous line if the response or macro is encountered.
```
CONNECT=remote computer response<macro>
```
Used at the end of a successful modem script. Not generally useful with the Switch.inf file.
```
ERROR=remote computer response<macro>
```
Causes Network Connections to display a generic error message if the response is encountered. Useful for notifying you when the remote computer reports a specific error.
```
ERROR_DIAGNOSTICS=remote computer response<diagnostics>
```
Causes Network Connections to display the specific cause for an error returned by the device. Not all devices report specific errors. Use ERROR= if your device does not return specific errors that can be identified with Network Connections diagnostics.
```
NoResponse
```
Used when no response comes from the remote device.

A connection always expects a response from the remote device and waits until a response is received unless a NoResponse statement follows the COMMAND= line. If there is no statement for a response following a COMMAND= line, the COMMAND= line executes and stops the script at that point.

For information about activating a Switch.inf script, see To activate a logon script. For more information about Switch.inf scripts, see Automating the dial-up logon process by using Switch.inf scripts.